Email:shibomachine@gmail.com

TEL:0086-371-55912969 

　　Maintenance method of spiral classifier is very diverse, and only pay attention to the words you can make better use of the machine. And there are high weir spiral classifier and double helix, sinking four kinds of single and double level.

　　Each week, the oil running gear to be replaced, should be replaced every six months did not run. Parts shaft grease is to be cleaned once a year. If you meet spiral lining worn must be promptly replaced.

　　For spiral classifier maintenance methods have a common four. Lubrication points must be sodium and calcium-based two lubricated and first look at the internal gear lubricant in each staff member on duty at the time. There is not a moment in the oil needle line, but also for the test run, then it is no problem to ensure normal operation. It also must be 6 month oil change. At the same time when using the seat and have regular check frame bearing, shaft, there is not a watch worn seals, bearing also a very important part, if you shun the bad will directly affect the performance of the product, so this is happening must be promptly replaced. Must ensure that the bearing is sealed, and should always be lubricated and oil control, preferably once every four hours.

　　Maintenance of spiral classifier is not only reflected in the surface, while the work load of the machine, do not let the machine run for a long time, to be able to withstand in the scope of work schedule. Especially in the shaft time to bear high temperature cooling, although there are automatic protection function, but if you wait for the machine to show that damage their own power outage has been great, so it's best running two hours is necessary to allow the machine to rest a bit bell started working again, so that you can increase the machines at least 2 years of life.